Medtronic Paradigm 522 Guide de l'utilisateur télécharger pdf (Page 27)

Tubing Connector

If insulin, or any liquid, gets inside the tubing connector, it can temporarily block the vents that allow the

pump to properly prime the infusion set. This may result in the delivery of too little or too much insulin,

which can cause hypoglycemia or hyperglycemia. To prevent liquid from getting inside the tubing

connector, after you fill the reservoir make sure you hold the insulin vial upright when you remove the

reservoir from the transfer guard. If you do not hold the insulin vial upright, insulin can get on the top of

the reservoir and could transfer liquid into the tubing connector. If any liquid gets on the top of the

reservoir or inside the tubing connector when you change your infusion set, start over with a new reservoir

and infusion set. For instructions on setting up your reservoir, see Filling the reservoir, on page 58. For

instructions on changing your infusion set, see Changing your infusion set, on page 60.

Tubing

connector

Top of

reservoir

Sensor

The sensor may create special needs regarding your medical conditions or medications. Please discuss

these conditions and medications with your doctor before using the sensor

Bleeding, swelling, irritation and/or infection at the insertion site are possible risks associated with

inserting the sensor and sometimes result from improper insertion and maintenance of insertion site.

Transmitter

Product contains small parts and may pose a choking hazard for young children.

Optional occlusive dressing should be removed if irritation or reaction to this develops.

The transmitter should be disconnected from the sensor while traveling on an aircraft, or if it interferes

with another transmitting device.

Introduction8

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 261 262

Pas de commentaire

Medtronic Paradigm 522 Guide de l'utilisateur Page 27