Medtronic Paradigm 522 Guide de l'utilisateur télécharger pdf (Page 175)

I cannot get out of the priming loop

There are several causes of and resolutions to this problem:

1 Is the reservoir pump full?

•

If no, place a full reservoir or shipping cap in the pump.

• If yes, make sure you are disconnected from the pump.

2 Hold the ACT button until the second set of beeps and the numbers appear on the screen.

• If yes, your pump is okay. Go to step 4 in the Manual prime section in the Starting on insulin

chapter to finish the manual prime.

• If you did not hear a second set of beeps or numbers did not appear on the screen, change your

infusion set and repeat this step.

3 If you still do not hear the beeps and see the number count on the screen, call the helpline or your

local representative.

The pump is asking me to rewind

This is normal after any of the following:

1 Any E-alarms,

2 The Clear Settings function,

3 Or, a NO DELIVERY Alarm (during the Prime sequence).

My bolus stopped

The Bolus Stopped error can occur if the battery cap is loose or the pump was bumped or dropped during a

bolus. It can also happen if the pump receives a static shock. As a safety measure, the pump stops the

bolus when this happens.

1 If you dropped your pump, visually inspect it to make sure that it is not damaged in any way.

2 Review your bolus history and reprogram the remaining bolus, if needed.

My pump buttons are not acting right during a bolus

If the

, or buttons are pressed and held down while a bolus is being delivered, the screen will

freeze on that amount. Once the button is released, the units will ramp up to the amount delivered so far

Pressing and holding down the button will not stop the delivery of a bolus.

Troubleshooting and alarms156

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 261 262

Pas de commentaire

Medtronic Paradigm 522 Guide de l'utilisateur Page 175