Medtronic Paradigm 522 Guide de l'utilisateur télécharger pdf (Page 180)

LOST SENSOR

Reason: The pump has not received a signal from the transmitter. Do not disconnect the transmitter

from the sensor.

Action:

1 Make sure that the sensor is inserted correctly.

2 Check the REVIEW SETTINGS screen to make sure that the transmitter ID entered into the pump

matches the ID on your transmitter:

Main > Sensor > Sensor Setup > Review Settings

3 Check the transmitter and sensor connection. Touch the inserted sensor at the back of the assembly to

prevent movement and push the transmitter firmly:

a. If you hear a click, wait 20 seconds and look for a green light on the transmitter flash for 10

seconds to confirm a good connection. If you see the green light, the alert was due to the

transmitter and the sensor not being connected.

b. If you hear a click, but do not see a green light on the transmitter, check to make sure that the

transmitter is charged.

c. If you do not hear a click when you check the connection, the alert was due to a transmission

problem. Bring the pump closer to the sensor and transmitter.

4 Use the Find Lost Sensor function to find your sensor (see the Troubleshooting sensor features section

in this chapter:

Main > Sensor > Sensor Start > Find Lost Sensor

LOW TRANSMTR

Reason: Occurs when the transmitter battery is close to running out of power. This alert will repeat daily

at noon while this condition exists. The transmitter will continue sending sensor signals for several hours

and may last for several days until the battery becomes depleted. Be prepared to recharge your

transmitter immediately when its battery becomes depleted.

Action: Recharge your transmitter as soon as possible. See the Charging the transmitter section of the

Sensor features chapter.

Troubleshooting and alarms 161

Chapter 13

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 261 262

Pas de commentaire

Medtronic Paradigm 522 Guide de l'utilisateur Page 180