Medtronic LIFEPAK CR-T Instructions d'exploitation télécharger pdf (Page 24)

14 LIFEPAK CR–T Trainer Operating Instructions

Using the LIFEPAK CR–T AED Trainer

Note: Ensure that the trainee does not touch the adhesive on the QUIK-PAK training electrodes or

allow a training electrode to fold over on itself. Also ensure that the training electrodes are correctly

oriented on the manikin as shown on the electrode packet (see Figure 8).

Figure 8 Placing Training Electrodes on the Manikin

Note: If the QUIK-PAK training electrodes accidentally detach from the manikin or disconnect from

the Trainer, the

CHECK PADS FOR GOOD CONTACT voice prompt will not sound. The instructor must

press the

ELECTRODE PADS button on the remote control to indicate that the electrode pads are

disconnected.

3 Upon ending a training scenario, press the lid release/ON-OFF button or close the Trainer lid to

simulate turning off the defibrillator.

The CHARGE-PAK indicator automatically appears on the

readiness display. To clear this indicator, the trainee must remove and reinsert the CHARGE-PAK or

the instructor must press the

CHARGE-PAK button (F3).

FOLLOWING A TRAINING SESSION

1 Remove the training electrodes from the manikin by grasping the electrode pad at the cable end and

peeling it away from the manikin at a 45° angle. Do not remove the training electrodes from the

manikin by pulling on the cable.

2 Reassemble the QUIK-PAK training electrode packet for the next training session.

3 Slide and release the

MASTER POWER switch to turn off the Trainer. (The Trainer automatically turns

off after 15 minutes of inactivity.)

4 Care for the Trainer as appropriate (refer to Section 4, beginning on page 23).

Note: Always place the Trainer in a location separate from the defibrillator to avoid confusion in

real emergencies.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Pas de commentaire

Medtronic LIFEPAK CR-T Instructions d'exploitation Page 24